haadial.blogg.se

1. Decrypted packet failed sa identity check cisco juniper plus#
2. Decrypted packet failed sa identity check cisco juniper download#

Decrypted packet failed sa identity check cisco juniper download#

Download one of them to use that as a reference. Click that and you will find a list of configuration scripts for our supported Then you should see a "Download" button at the bottom. If so, you may drill down to one of your virtual networks. I assume you have already got access to the portal. Please double-check and make sure these parameters are properly specified in your configuration for the WatchGuard device. Or it does not recognize the traffic selectors (basically the subnet ranges on both sides) specified in the first message. your WatchGuard device) does not like the cryptographic transforms specified by the Azure gateway That seems to indicate either the responder (i.e. We recommend a lifetime of 3600 seconds and a lifetime-size of 10240000 KB or more.īased on the error message, your P2 negotiation failed on the first message at the responder side. What settings should i configure each phase for on our side when trying to connect to Azure VPN? Thanks!Īzure supports the following crypto settings for Phase 2 negotiation:

Decrypted packet failed sa identity check cisco juniper plus#

Plus the network on our Azure VPN is 192.168.4.0/24 so i'm not sure where it is getting the 192.168.4.5 IP address from? Since we are not using a Cisco or Juniper device i'm having issues trying to configure our router to accept the connection. 12:59:49 iked Searching ID: IP address - policy peerId msg_id="0203-4011"

All looks good but then i get the following error: 12:59:48 iked Process 5/6 Msg : failed to process ID payload 4 I configure the gateway (phase1) and the tunnel (phase2) and put in the Azure generated shared key. The device is a WatchGuard X500 and we already have a few VPN connections to our other sites. I'm trying out the new VPN feature and connect it to our on site VPN device.